Press Windows key and type in “Change advanced startup options”, and enter the options. This section shows the hardware components, their dimensions, and lists the pins, operating conditions and power requirements. Altera Quartus Programmer, Kernel mode driver not. To get the USB Blaster working first insert the device into your Mac's USB port and go to Machine settings -> Ports and select the USB tab. This is due to the fact that Windows 8 doesn’t allow you to install unsigned drivers by default so you need to disable this security option. The Intel FPGA Download Cable has a universal USB connector that plugs into the PC USB port, and a female connector that plugs into a male header on the device board. Altera quartus usb blaster: Problem with the Altera USB Blaster programmer. Now, if you follow the instruction from Altera USB blaster install you probably get to step 8 of the instructions after which you are not prompted with a window mentioned on step 9. On my system it is located in:Ĭ:\altera\15.0\quartus\drivers\usb-blaster\ You probably already have it if you installed Quartus II, it comes with the installation. I lost a significant amount of time to make the driver work on Windows 8.1 so to speed things up for you, here is what you do.įirst, you need to obtain the driver to be installed. As far as I know there is no problem in installing the driver on Windows 7 but if you are using Windows 8 or 8.1 then you probably ran into the problem of Windows not allowing you to install unsigned drivers. Back on the Win7 computer I tried using the command prompt to open altera\11.2sp2\quartus\bin\jtagconfig.exe and saw it read out the message "No JTAG hardware available".I started playing around with FPGA development using the Terasic DE0 development board recently and the first problem I encountered was the installation of the USB blaster driver. In troubleshooting, I also tried installing the same version of Quartus II and the USB blaster on my Win10 laptop, but the driver isn't signed for win10 so I dropped that approach. After connecting the USB Blaster to my Win7 computer for the first time and installing the driver from altera\11.1sp2\quartus\drivers, the USB Blaster shows up in the control panel as "USB-Blaster(Altera)" but Quartus II doesn't show it in the Programmer's Hardware Setup page. After that you should install the driver successfully. Select 'Browse.' to select the driver we have provided to you, then click Next to install the driver. Select 'Browse my computer for driver software'. Because I have this Ep2c5/ep2c8 dev board, I've been following this video to begin my work with FPGAs: Right-click on the 'USB Blaster' and then select 'Update driver '.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |